Updating bios for girls
You better use the automatic flasher, type "go -fdid 9235" from DOS.Make screenshots from Ctrl M and MSU, check Device Manager, upload screenshots and give valuable feedback. Cannot say for sure, as I never used MSU before this problem.Try 184.108.40.2068 and then 220.127.116.115 from attached archives.
MSU detects it as well and the PCI-E link speed is correct: So I went to try the A1 version image to see if I hadn't flashed the correct one. It would also have been helpful to post one from Ctrl M.I have access to a programmer device, so if the image can be somehow built to be programmed to the SPI flash (my card has Macronix MX25L4006E) probably that could be used to recover it?Ofcourse I don't have any backup of the original image that was on the card Any help from you Marvell gurus is highly appreciated!The one component that makes a big difference is the Autoload, even if it is a few bytes long.The other specific component is the OROM (called BIOS in Marvell Firmware), but this one usually has a list of supported IDs, thus it should pick the right ID.